SAF OPAL Ethernet IP Interface MS6 SERIES Manuale Utente Scaricare il pdf (Pagina 8)

Opal Pro to SAF GlobalData

Page 8

Opal Pro Parameter Settings

The parameters in the Opal Pro used to configure the Ehernet interface

card (group 14) are only accessible if a Ethernet interface card is installed.

The parameter settings are as follows:

Opal Pro

Parameter

Setting

Description

2.02 Comm Module

Ethernet

Type of interface card installed

(read only)

10.01 Start/Stop

Comm

Module

This allows the Opal Pro to be

started and stopped over the

communication link

10.04 Iref Source

Comm

Module

If this is set to Comm Module the

Opal pro will follow the Current

refernce from the communication

link. If there is no reference being

sent on the communication link this

should be set to “Internal”

10.05 Phase Angle

Source

Comm

Module

If this is set to Comm Module the

Opal pro will follow the Phase

Angle reference from the

communication link. If there is no

reference being sent on the

communication link this should be

set to “Internal”

14.07 Node

1 – 254

This is the Node # of the Opal Pro

14.08 IP Addr 1

0-255

First number in the IP address of

the Opal Pro

14.09 IP Addr 2

0-255

Second number in the IP address

of the Opal Pro

14.10 IP Addr 3

0-255

Third number in the IP address of

the Opal Pro

14.11 IP Addr 4

0-255

Fourth number in the IP address of

the Opal Pro. (the node number as

set in 14.07 is added on to this

number to get the final IP address)

14.12 SubNet 1

0-255

First number in the SubNet Mask

14.13 SubNet 2

0-255

Second number in the SubNet

Mask

14.14 SubNet 3

0-255

Third number in the SubNet Mask

14.15 SubNet 4

0-255

Fourth number in the SubNet Mask

1 2 3 4 5 6 7 8 9 10 11 12 13

Commenti su questo manuale

Nessun commento

SAF OPAL Ethernet IP Interface MS6 SERIES Manuale Utente Pagina 8

Commenti su questo manuale

Prodotti e manuali riguardandi Networking SAF OPAL Ethernet IP Interface MS6 SERIES